Safety first: Remove the robot from the pool using the approved retrieval method. Power it off and dry the charge port before attaching the OEM charger. Never open its sealed battery case or test submerged motors on a dry surface.
Model and version covered
Original Aiper Scuba S1. Check product-year and full label: Scuba S1 2025/2026, S1 Pro and other Aiper models may have different app, LED and button features.
DIAGNOSE THE CAUSE · APPLY THE FIX · CONFIRM THE RESULT
Find the cause and fix it
Jump to your symptom: 01 · No light after storage02 · Charger works but buttons unresponsive03 · Water found inside electronics housing
01
No light after storage
HOW TO CHECK & CORRECT THIS CAUSE
- Dry exterior/charge contacts and charge on genuine adapter per manual until full, then perform documented power-on/short reset test above water.
How to tell it is fixed: Status LED lights and correct pool mode starts.
02
Charger works but buttons unresponsive
HOW TO CHECK & CORRECT THIS CAUSE
- Inspect externally for stuck power button, use approved reset once.
- If still dead, authorized sealed battery/control service is required.
How to tell it is fixed: Robot starts and completes normal cleaning after repair.
03
Water found inside electronics housing
HOW TO CHECK & CORRECT THIS CAUSE
- Do not energize or recharge.
- Replace compromised sealed electronics via Aiper service to avoid shock/battery hazards.
How to tell it is fixed: Water-tight rated module works normally after repair.
Source and model restrictions
Technical baseline: Manufacturer guide or model manual ↗