Safety first: Switch the robot off and unplug the dock before clearing brushes, ducts or contacts. Keep liquids out of the dock and LDS. Use only the specified base and battery components.
Confirm exact model and variant
Use only Dreame D10 Plus Gen 2 (RLD32GD) and its matching auto-empty base (RCDD0202). Original D10 Plus/D10s Plus instructions or app features may differ by version.
DIAGNOSE THE CAUSE · APPLY THE FIX · CONFIRM THE RESULT
Find the cause and fix it
Jump to your symptom: 01 · Floor becomes soaked on normal hard floor02 · Wet trails concentrate at water tank seam03 · Excess water persists despite low setting
01
Floor becomes soaked on normal hard floor
HOW TO CHECK & CORRECT THIS CAUSE
- Set lower water-flow level in app, use correct mop pad fully attached and wrung/prepared per manual, avoid mopping inappropriate absorbent carpet.
How to tell it is fixed: Thin even moisture film dries promptly after pass.
02
Wet trails concentrate at water tank seam
HOW TO CHECK & CORRECT THIS CAUSE
- Remove tank and check cap/gasket and mounting, reseat or replace leaking tank/cap assembly.
How to tell it is fixed: No standing drips with tank installed but robot stationary.
03
Excess water persists despite low setting
HOW TO CHECK & CORRECT THIS CAUSE
- Stop use to prevent floor damage.
- Water regulation valve/tank assembly needs matched repair rather than drilling outlet smaller.
How to tell it is fixed: Water level controllable across app settings.
Model source and method basis
Reference: Read corresponding manufacturer/manual source ↗
The fault definitions, named controls and any published specifications follow the linked documentation. Ordered isolation tests are conservative explanatory procedures, not a claim that all checks are verbatim factory service instructions. If the stated manual does not establish a measurement or part compatibility, this guide deliberately does not invent it.